Page 1 of 1

[Bug 1.46 & 1.47] Fit AirCon wrong requirements

Posted: Sat Mar 03, 2018 5:36 pm
by swhitlock
To reproduce this:

  • Make two models: one has no options, the other has only Climate Control, schedule both alternately
  • Make an assembly line that runs through a single Fit AirCon slot with climate control upgrade purchased
  • (Optionally) set Fit AirCon slot to import AirCon module from Local Only, but don't produce any locally --> this will make the bug more obvious
  • Run

When the upgraded model (with Climate Control) gets there, it fits a single climate control module. When the base model gets there it normally just releases it without doing anything, which is correct. However, the requirement on the base model still shows up as 1 AirCon unit.

This creates two weird scenarios depending on whether or not you told it to use Only Local Aircon modules. If you did, the base model will stop at the slot and refuse to release the car because it can't get any AirCon modules.

The more subtle and expensive behavior, if it can get AirCon modules, is that it will order 4 or 5 and keep them in stock. However, like all slots, since it doesn't consume AirCon modules, after a few cars go through, it'll throw out those AirCon modules, but then order more when the next base model gets there. So you're consuming AirCons even though none are going on cars, and it's wasting time waiting for resources to arrive.

The literal work-around is to use a Smart Junction to send your upgraded models through the Fit AirCon slot, and send your base models around it.

Re: [Bug 1.46] Fit AirCon wrong requirements

Posted: Mon Mar 12, 2018 9:38 pm
by swhitlock
This bug still seems to exist in 1.47. Here's a screenshot of a sedan that doesn't get any features (no aircon) stuck at the Fit Aircon slot because I've told it to only use local aircon resources:

FitAircon Bug Insufficient Resources.png
FitAircon Bug Insufficient Resources.png (2.34 MiB) Viewed 2817 times

Here's a screenshot showing the model in question has no AirCon requirement, even though the slot says it's a requirement:

FitAircon Bug Model Has No Aircon.png
FitAircon Bug Model Has No Aircon.png (1.43 MiB) Viewed 2817 times