Default orientation of conveyor

Ideas for gameplay improvements and changes. NOT bug reports!
Type III Robot
Type III Robot
Posts: 97
Joined: Sun Oct 01, 2017 8:55 pm

Default orientation of conveyor

Postby mattz0r » Sat Nov 25, 2017 12:26 am

I didn't think is a bug as such, just an annoyance at the moment.

I think it would be a good idea to automatically rotate/fit the conveyor based on the existing ones, rather than a default direction.

If you plonk down a conveyor, without "dragging" it the direction you want it to face, you may end up with "Conveyor in wrong direction", when placing it on a rotated production unit, but the conveyor is facing the other way.

Just a little thing that would go a long way to improving the smoothness of playing.
Type III Robot
Type III Robot
Posts: 85
Joined: Thu Nov 09, 2017 2:50 pm

Re: Default orientation of conveyor

Postby TontoMcTavish » Sat Nov 25, 2017 12:42 am

I actually like that idea too. I've done it loads of times where I've needed the one square, clicked and then realised it was the wrong way.

Return to “Suggestions”

Who is online

Users browsing this forum: No registered users and 1 guest